Wiring NI9208

[smcgeown]

Hi All,

I am currently trying to measure pressure using a Wika R1 pressure transducer.

I am using NI9028 with DSUB Terminal Pinout.

There is existing equipment already, so I am wiring into terminal 22 and terminal 14.

I am current not getting any put reading to LabVIEW.

Am I reading the wiring diagram wrong or is there an other issue? 

[ZYOng]

Did you connect an external power supply? 

You need to wire correctly, depending on your sensor type.

Reference: NI 9208 Getting Started Guide

[smcgeown]

I am currently wiring into an existing board that measures pressures in other tests.

The previous employees have soldered on to the pins so I carried out the same procedure.

The Wika R1 is a two cable pressure transducer one goes to the 24V (pin 22 new solder) and signal to pin 17 AI14 (existing wire).

I did have it connected to another pin at one point which was giving out a 10-7 number.