How do I wire Load Cell to AT-MIO-16XE-50?

[Gino]

I am trying to wire load cell to AT-MIO-16XE-50. Load cell consists of +in, -in, +out, and -out. Excitation Volatage is 15.0V.

According to AT-MIO-16XE-50 manual, AOGND is not available in it. I hope that anyone will be able to give me a pin mapping. (The load cell is about to connected to AT-MIO-16XE-50 directly.)

[RamziH]

Hi,

The pinout of the card is found on page 4-2 of the manual (AOGND is pin 55). In any case, the card is not designed to work with load cells. There are other modules that are designed for load cells - check the following:

Resources: Keywords Search: load cell measure

Modules: Keywords Search: load cell

Regards,
RamziH.

Message Edited by Molly K on 02-19-2005 12:07 AM

[archy]

In my lab, the load cell is connected to the SCB-68. I use the the NRSE mode. So I don't use the GND on it. But I am not sure if I made a correct signal conection?
Can somebody tell me if the load cell signal is a grounded signal?

Thanks you very much in advance?