SignalExpress Tektronix Edition with TDS2014C

[Viper32]

I have the full version of SignalExpress Tektronix Edition to use with a Tektronix TDS2014C 4-channel scope.  Unfortunately SignalExpress will only show me Channel 1 and Channel 2.  I have yet to figure out how to get it to display Channels 3 and 4.  Below are the steps I take:

Add Step -> Tektronix -> Acquire Signals -> Tek TDS1000/2000

The image below is what SignalExpress gives me.  Any suggestions?

[Perry_S]

Hi Viper32,

WHat version of SignalExpress Tektronix edition do you have? Did you have to install any drivers for the TDS2014C? If so what version? Let me know.

Regards,

Perry S.

[Viper32]

Hi Perry,

I am running SigEx Tek edition ver 2.5.1

I don't recall installing any drivers, however I looked in the device manager and here is what it says

USB Test and Measurement Device

Driver Provider: National Instruments Corporation

Driver Date: 10/31/2006

Driver Version: 1.0.0.0

Digital Signer: National Instruments Corporation

[Perry_S]

Hi Viper32,

Here is a link to the lates version of the driver. Install it and see if this helps the issue. It was updated in 2008.

Regards,

Perry S.