Home Community Discussion Forums Most Active Hardware Boards Instrument Control (GPIB, Serial, VISA, IVI) Topic

Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Need to communicate between computer running Windows 2000 & labview 5.1 & a UMAC 1050 serial board and examples? Hard drive crashed!

Need to communicate between computer running Windows 2000 & labview 5.1 & a UMAC 1050 serial board and examples? Hard drive crashed!

‎09-12-2003 10:53 AM

I have a computer running Windows 2000 on it. Had windows 5.1 loaded on it and was communicating via RS232 out serial port to a UMAC 1050 board to collect/transmitt analog and digital signals. Hard drive crashed and have installed new one. No backups and trying to restore computer. Reinstalled labview from disk but can't get Umac to talk. Any drivers needed or sample programs to test it?
0 Kudos
Message 1 of 2
(3,384 Views)
Reply

Re: Need to communicate between computer running Windows 2000 & labview 5.1 & a UMAC 1050 serial board and examples? Hard drive crashed!

‎09-16-2003 02:39 PM

Hi Laurie,

The LabVIEW installer should install all the necesssary drivers.

What serial VIs are you using? (VISA or the "direct" serial).

What is the error code you are getting? or what is the behavior you are seeing?.

DiegoF
National Instruments.
0 Kudos
Message 2 of 2
(3,384 Views)
Reply