anyone using an Agilent U3606A?

[Christopher80]

I will change this in the program. Thank you for the help

[Dennis_Knutson]

Change what? There is nothing wrong as far as I can tell. Actually put a probe on the VISA Write input first and report what is there.

[Christopher80]

I was trying to apply the changes that Jeff mentioned. However I couldn't get it to work. So I am still not able to turn off the auto range on my device. The auto range is causing delayed measurements in my VI.

[Dennis_Knutson]

Well, did you do what I asked? Did you actually probe what the VISA Write is sending? Did you turn on NI-Spy/NI-Trace to capture the write? Do one or the other and compare what the manual says to turn ofauto-ranging.

[Christopher80]

I just edited the read output vi and it took care of my problem. thanks for the help

[Dennis_Knutson]

Attach what you have done. I don't understand how a modification to a read can change what you said what a problem writing.

[Christopher80]

Here it is.

[GHernandez]

Can you post a screenshot of the pre-/after changes? I am using the supplied VI's as well and the configure measurement function just hangs on me. What i mean is that the Over Current flashes on the instrument, but it does not overcome this.

Thank You

[KyleP]

Hi GHernandez,

It sounds like you're getting a different problem than what was previously posted. Are you using the drivers available on this page?

Cheers,

[GHernandez]

Yes. I am using the VIs supplied by National Instruments. I've attached screenshots of the subVI calls and the Main Vi. I made a test vi that will call this function. It hangs at setting the current limit. It will flash on the front panel and not do anything else.