Error 200320: Chassis SCXI 1001 - Mod 1502

usuario · ‎01-12-2009

Hello there.

I'm setting for first time a SCXI 1001 chassis with several modules, 3 of them 1502 with their 1314 terminal blocks. I've used this chassis before to read some temperatures and worked fine, so I'm pretty sure the problem is me.

I get this error 200320 about simultaneous sample and hold when trying to aquire strain data, but I think the configuration is fine. I'm still pretty new on LabView and have tried checking the setup both by the Data Aquisition Express module and by MAX; but I get same result.

Please help me to set this up as soon as posible, I need your knowledge.

Thanks,

usuario

GrahamG · ‎01-12-2009

Hi usuario

check out this Knoledgebase article it should answer a few of your problems.

http://digital.ni.com/public.nsf/allkb/F5529A0EF8ADDA288625713400613065?OpenDocument

If you have further troubles then post back and I'll try and assist further.

best regards

Graham Green

Sr. Product Marketing Manager

National instruments

usuario · ‎01-12-2009

Hi Graham,

one of my problems is that I'm too new in LabView. I haven't assisted to any courses and have to learn by myself. I just read that article before posting this question.

I still don't know exactly what exactly is a task; neither how to create channels in LabView and how to specify the aquisiton conditions, and so, I'm limited to using the DaqAssistant Express Module. I can't find where can I change this setting there.

I used to aquire using DasyLab before, and I'm still fighting to make myself to LabView.

Thanks,

Usuario

usuario · ‎01-13-2009

I am finally able to aquire the signal from the gauge. I've taken one the LabView examples and changed it a little. But I have a new problem now. I attach the .vi.

How do I tell the system to perform the shunt calibration?

Thanks,

usuario